Installing Ian Cull's Auto-Up Window Circuit is much easier than installing the reverse, emergecny brake and speed pulse wires. Trust me.
There are two ways to plug the adaptor into the back of the toggle switch bay: blind install (Ian explains this on his site) and not-so-blind install.
I opted for the latter.
There are to little clips that keep the A/C panel firmly in place. Use your thumb to squeeze these inwards and the A/C panel will drop out. Now you can remove the toggle panel in the same fashion.
Unplug the wire-ribbon that connects to the back of the toggle panel and plug it into the circuit board of Ian's adaptor.
Next, plug the circuit ribbon into the back of the toggle panel.
Stuff the circuit board into the dash and set the toggle panel in place. Make sure to "click" the A/C panel back in place as well.
That's it!
No comments:
Post a Comment